cm6520 1-19Before use 1Before use Chapter 1Selecting the position of the binding margin (Original Binding Position/Binding Position settings)If a double-sided document is loaded into the ADF, specify the position of thetop of the back side of the document by specifying the binding margin positionfor the document.1 Position the document to be copied.– For details on positioning the document, refer to "Feeding the document"on page 1-11.2 In the Basic screen, touch [Duplex/Combine]. Otherwise touch theOriginal/Density tab.Setting DescriptionLeft Select this setting if the document is loaded with the binding margin at theleft.Top Select this setting if the document that is loaded has a binding margin at thetop.Right Select this setting if the document is loaded with the binding margin at theright.Auto With this setting, the binding margin is set at the top or at the left.Select this setting to automatically select the position of the binding margin.If the document length is 11-11/16 inch (297 mm) or less, a binding positionalong the long side of the paper is selected.If the document length is more than 11-11/16 inch (297 mm), a bindingposition along the short side of the paper is selected.
