Installing Client Software for Raw TCP/LPR Printing 35Installing Client Software for Raw TCP/LPR PrintingThis section describes how to set up the printer drivers for Raw TCP/LPR printing which is avail-able for the local area network over TCP/IP.There are Two ways to set up the printer drivers for Raw TCP/LPR printing:y Using the installer in the Client Utilities CD-ROMYou can set up the printer drivers for Raw TCP/LPR printing by installing the printer driversusing the installer in the Client Utilities CD-ROM. Then you install and configure the RawTCP or LPR port to configure the connection.P.35 “Installation for Raw TCP/LPR Printing Using the Installer”y Using Add Printer WizardWhen you want to install the printer drivers without using the installer, or when you want toinstall the same printer driver for another equipment, install the printer drivers using the AddPrinter Wizard.P.48 “Installation for Raw TCP/LPR Printing by Add Printer Wizard”y Before operating the following setup, check with your system administrator to make sure ofthe following:- This equipment is connected to the network and turned on.- The TCP/IP setting is correct on this equipment and your computer.y Raw TCP Printing is only available for Windows 2000, Windows XP, and Windows Server2003.y LPR Printing is only available for Windows NT 4.0, Windows 2000, Windows XP, and Win-dows Server 2003.Installation for Raw TCP/LPR Printing Using the InstallerInstall the client software using the installer in the Client Utilities CD-ROM first, then configurethe Raw TCP or LPR port in each printer driver.Installing the client software for Raw TCP/LPR printing using the installerThe following describes an installation on Windows XP. The procedure is the same when otherversions of Windows are used.You must log into Windows as a user who has the “Administrators” or “Power Users” privilegewhen using Windows NT 4.0, Windows 2000, Windows XP, or Windows Server 2003.1 Insert the Client Utilities CD-ROM into the CD-ROM drive.y The installer automatically starts and the Choose Setup Language dialog boxappears.y If the installer does not automatically start, double-click “Setup.exe” in the Client Utili-ties CD-ROM.2 Select your language and click [OK].y The License Agreement screen is displayed.
