Oce im4511 Operator's Manual

Also see for im3511: Programming Date & Time Facsimile operation manual Operation manual Operating manual Operation manual

Contents

Oce im4511 Operator's Manual Manual pdf 12 page image

10GENERAL PROGRAMSOperation settingsThe "Operation settings" are related to basic operationof the machine and consist of the following programs: Keys touch sound Auto clear setting Disabling of job priority operation Message time setting Disabling of bypass printing Display language setting Key operation setting Disabling switching of display order Disabling of clock adjustmentKeys touch soundThis program is used to adjust (or turn off) the volumeof the beep that sounds when you touch a key. You canalso have three beeps sound at base values whensetting the ratio in copy mode or adjusting the exposurein any mode.To change the volume, touch the desired volume key.When "KEY TOUCH SOUND AT INITIAL POINT" isselected, three beeps will sound at the base settingvalues indicated below.Auto clear settingIf the machine is not used for a certain duration of time,the auto clear function will clear any settings that havebeen selected and return the screen to the main screenof copy mode or the job status screen. This program isused to set the duration of time after which auto clearoperates. The time can be set from 10 seconds to 240seconds in increments of 10 seconds, or the auto clearfunction can be disabled. (Note that auto clear can onlybe disabled for copy mode.)Disabling of job priority operationThis program is used to prohibit use of the [PRIORITY]key in the job status screen.Message time settingThis program is used to set the length of time thatmessages appear in the display (this applies tomessages that appear for a certain length of time andthen automatically disappear.)The time can be set to as long as 12 seconds inincrements of one second.Disabling of bypass printingWhen a job cannot be printed because there is nosuitable paper and there is a subsequent job that canbe printed, the subsequent job will be printed ahead ofthe job that cannot be printed *1 (page 1-15 of the"Copying operation manual"). This program can beused to disable printing of subsequent jobs in thissituation.*1 Except when paper runs out in the middle of a jobDisplay language settingThis program is used to select the display language.Key operation settingThese programs are used to set the length of time akey in the touch panel must be touched before the keyinput is registered, and to prevent repeated key inputwhen a key is touched continuously.• Time until key input is registeredThe time can be set from 0 seconds to 2 seconds inincrements of 0.5 seconds. Normally the time is setto 0 seconds so that key input is immediatelyregistered when a key is touched. By lengthening thetime setting, key input can be prevented when a keyis touched accidentally. Keep in mind, however, thatwhen a longer setting is selected more care isrequired when touching keys to ensure that key inputis registered.• Prohibit key repeatThe touch panel contains keys such as the zoomkeys (for setting the ratio) that can be touchedcontinuously to make a value change until it reachesa desired value.This feature whereby a value changes continuouslywhile a key is touched is called key repeat.Key repeat is normally enabled. If you wish to prohibitkey repeat, select the "DISABLE AUTO KEYREPEAT" checkbox.Screen in which setting iseffective Base valueRatio setting screen in mainscreen of copy mode Ratio = 100%Exposure adjustment screen inmain screen of copy modeExposure level3(middle level)Exposure adjustment screen inmain screen of fax, Internet fax,and network scanner modesExposure adjustment screen in[SCAN TO HDD] in mainscreen of document filing modeKEY OPERATOR PROGRAMSOKKEYS TOUCH SOUNDKEY TOUCH SOUND AT INITIAL POINTKEYS TOUCH SOUNDOffVolume: HighVolume: Low