Oce im4512 Settings Manual

Also see for im3512: Programming Date & Time Facsimile operation manual Operation manual Operation manual Operation manual

Contents

Oce im4512 Settings Manual Manual pdf 18 page image

16COPY SETTINGSThis section explains the administrator settings that are used for copy mode.Copy settings"Copy settings" consists of the following settings:● Initial status settings● Exposure adjustment● Rotation copy setting● Add or change extra preset ratios● 600dpi x 600dpi scanning mode for documentfeeder● Quick scan from document glass● Initial margin shift setting● Erase width adjustment*1● Card shot settings*1● Setting a maximum number of copies● Disabling deletion of job programs● Disabling of bypass-tray in duplex copy● Disabling of auto paper selection*1 Default settings selected with these settings applyto all functions of the machine (not just the copyfunction).Initial status settingsThe copy settings revert to the default settings whenthe power switch is turned on, when the [CA] key ispressed, or when the auto clear time elapses. Thissetting is used to change the default settings, or returnchanged default settings to the initial factory defaultsettings.Defaults for the following copy settings can bechanged:Paper tray/Exposure tray/Copy ratio/2-sided copy/Output (auto, sort, staple sort, group, output tray)Exposure adjustmentThis setting is used to adjust the exposure level when"Auto" is used for the copy exposure.The factory setting is "5". "1" indicates lighter densityand "9" indicates darker density on the touch panel.Rotation copy settingThis setting is used to have the image of an originalautomatically rotated when the orientation of theoriginal does not match the orientation of the copypaper.(Rotation copy will function only if the auto paper selector auto image mode has been selected.)Add or change extra preset ratiosWhen using inch sizes, there are normally four presetenlargement ratios and four preset reduction ratios.When using AB sizes, there are normally five presetenlargement ratios and five preset reduction ratios.This setting allows you to add two more presetenlargement ratios and two more preset reduction ratios.This setting also allows you to change a preset ratio.600dpi x 600dpi scanning mode for documentfeederUse this setting to change the original scanningresolution of the automatic document feeder from 600x 300 dpi to 600 x 600 dpi.If this mode is set, the copy quality for fine charactersand fine lines will be improved but the original scanningspeed will be slower.Quick scan from document glassUse this setting to change the original scanningresolution on the document glass from 600 x 600dpi to600 x 300 dpi.When this setting is enabled, the first copy time will beshorter, however, copy images will be slightly coarser.NOTEIf this setting is used to change the default setting forthe duplex function to other than "one-sided""one-sided" and the automatic document feeder failsor is disabled*, the setting will revert to "one-sided""one-sided".* DISABLING OF DOCUMENT FEEDER (page 11)DISABLING OF DUPLEX (page 11)NOTETo copy an 5-1/2" x 8-1/2" or A5 size original onto5-1/2" x 8-1/2"R or A5R paper, this setting must beenabled.NOTEOnly an added preset ratio can be changed.NOTEIf you prefer a quicker scanning speed over higherresolution, do not enable this setting.NOTEIf you prefer a higher quality copy image over ashorter first copy time, do not enable this setting.