48 Microline 320/321 Turbo|Automatic Forms Tear-OffForms Tear-Off must be set to ON in the menu for AutomaticForms Tear-Off to occur.Automatic Forms Tear-Off automatically moves the paperfrom the initial printing position (print start position) to thetear-off position, after a time interval which you selectthrough the menu.The top of the page (perforation) is even with the tear bar.The tear bar is located under the clear top of the access cover.Paper remains in the tear-off position until the printerreceives more data. Then, the paper moves back down forprinting (retracts to the initial print position).When printing stops, the paper advances to the tear-offposition.TEAR Key and Automatic Forms Tear-OffIf you press TEAR (1) when Forms Tear-Off is turned on(activated in the printer menu), the printer retracts the paperto the Top of Form position.32T-FP.epsQUIETPARKTEARFF/LOADLFSELSELPOWER ALARM MENUGROUPEXIT ITEM SET PRINTMENU SHIFT TOFMicro FeedUpMicro FeedDown! The status of the Forms Tear-Off menu setting affectshow you set the Top of Form.To determine the status of the Forms Tear-Off menusetting, refer to “Using Your Printer, Top of Form,Forms Tear-Off Status (ON or OFF).”For information on setting the Top of Form, refer to“Using Your Printer, Top of Form, Setting Top of Form,Forms Tear-Off (ON or OFF).”! If the software package you are using “pauses” whilesending data to the printer, Forms Tear Off may beactivated (if it is enabled through the Menu). The pausemust be for two or more seconds. No data is lost. Unevenprint registration will occur due to the paper movement.If the problem occurs, use the menu to turn off thisfeature.! DO NOT use Forms Tear Off with labels or multi-partforms!! Forms Tear-Off CANNOT be used when the optionalpull tractor is engaged.1
