52 Microline 320/321 Turbo|Changing Paper PathsContinuous-forms to single-sheet feed1 Tear off any printed pages.2 Press PARK.3 Raise the paper separator to the single-sheet feed position.4 Place the wire feed guide in the paper separator.5 Move the paper lever to the position marked “TOP.”The paper lever is towards the back of the printer.6 Place a sheet of paper in the paper separator.32T-12.epsSingle-sheet feed to continuous forms1 Press FF/LOAD to remove the single-sheet paper.2 Lower the paper separator into the continuous-formsposition. Swing the wire feed guide over onto the pull-uproller.3 Move the paper lever to the appropriate positionFor rear feed (1), the paper lever is towards the front of theprinter.For bottom feed, (2), the paper lever is in the centerposition.4 If necessary, load continuous-form paper.5 Press FF/LOAD.32T-11.eps and21
