40055101TH Rev.4 603 /3. PARTS REPLACEMENTThis section covers the procedures for the disassembly, reassembly and installations in the field.This section describes the disassembly procedures, and for reassembly procedures, basically proceed with thedisassembly procedures in the reverse order.3.1 Precautions Concerning Parts Replacement(1) Parts replacements must be carried out, by first turning the facsimile power switch off “O” and removingthe facsimile from the Second Paper Feeder.(2) Do not disassemble the Second Paper Feeder if it is operating normally.(3) Establish the extent of disassembly suitable for the purpose of the procedure, and do not disassemble anymore than necessary.(4) Only specified service tools may be used.(5) Disassembly must be carried out according to the prescribed procedures. Parts may be damaged if suchprocedures are not followed.(6) Small parts such as screws and collars can easily be lost, therefore these parts should be temporarily fixedin the original location.(7) When handling printed circuit boards, do not use any glove which may generate static electricity.(8) Do not place the printed circuit boards directly on the equipment or floor.
