Duplex module — 67Setting the printer driver for duplexmodule, bypass tray and exit trayWhen using the duplex module (including thebypass tray and the exit tray) for printing,select “Properties” and make selections asfollows for the print job.The screens used in the following descriptionsare for a PCL driver in the Windows 98environment.Two-sided printingOpen the “Main” tab and check the radiobutton of the desired two-sided printing mode.Using the bypass trayOpen the “Paper” tab shown in the illustrationbelow and select “Bypass Tray” in the “PaperSelection” drop down.Using the exit tray mounted to the duplexmoduleOpen the “Paper” tab shown in the illustrationbelow and select “Left Side Tray” in the“Output” drop down.The settings screens shown will appear only ifthe devices have been set properly in theprinter driver configuration.The combination of paper selection and otherfunctions may not be compatible. For instance,if heavy paper, envelopes, label stock, etc. areselected, it will not be possible to selectduplex, offset tray, saddle stitch, etc.
