Oki C710 Maintenance Manual

Also see for C710: How to remove Jammed Paper Brochure & specs Safety and regulatory information

Contents

43856301TH Rev.3 117 /Oki Data CONFIDENTIAL 5. Maintenance Menu5.6 Printer boot menu listWhile pressing the SET button, turn on the power to display the Boot Menu.Memo To display the Boot Menu, entry of password is required. Default value of passwordis "aaaaaa".Category Item Setting value FunctionEnterPassword ************ Enter password to enter Boot Menu.Enter the password of 6 to 12 digits of alphanumeric.The initial value is "aaaaaa".ParallelSetup Parallel Enable Setting Valid/Invalid of parallel interface.DisableBi-Direction Enable Setting Valid/Invalid of bi-direction of parallelinterface.DisableECP Enable Setting Valid/Invalid of ECP mode.DisableAck Width Narrow Setting the ACK width when receiving the compatibledata.NARROW = 0.5 μsMEDIUM = 1.0 μsWIDE = 3.0 μsMediumWideAck/BusyTiming Ack in Busy Setting order of outputting the BUSY signal and theACK signal when receiving the compatible data.Ack while BusyI-Prime 3 microseconds50 microseconds Setting Valid time/Invalid of the I- PRIME signalDisableOfflineReceive Enable Setting Valid/Invalid of the function that enables tokeep the signal reception possible without changingI/F signal even when an alarm is issued.DisableCategory Item Setting value FunctionUSBSetup USB Enable Setting Valid/Invalid of USB interface.DisableSpeed 480Mbps Setting the maximum transfer speed of USBinterface.12MbpsSoft Reset Enable Setting Valid/Invalid of Soft Reset.DisableOfflineReceive Enable Setting Valid/Invalid of the function that enables tokeep the signal reception possible without changingI/F signal even when an alarm is issued.DisableSerialNumber Enable Setting Valid/Invalid of USB serial number.DisableSecuritySetup Job Limitation Off Limits the job to accept. The encryptedauthentication print only is accepted.It is displayed when the optional internal hard disk isEncrypted JobReset CipherKey Execute Re-generates the encryption key that is used in theencrypted hard disk.It is displayed when the optional internal hard diskis installed, and the encrypted hard disk function ismade valid.StorageSetup Check FileSystem Execute Resolves the un-match between the actual (free)space and displayed free space of file system, andrecovers the control data (FAT information.)Check AllSectors Execute Recovers the HDD sector information defect and un-match of the above file system.Enable HDD No A printer can start up even if HDD cannot start asit is damaged when it is installed, by setting "No"regardless of the HDD installation as a printerrecognizes that HDD is not installed.YesErase HDD Execute Deletes all data stored in a hard disk so that thedata cannot be recovered.It is displayed when the optional internal hard disk isinstalled.EnableInitialization * NoYes The internal hard disk and flash memory are set sothat they cannot be changed including initialization.*: It is displayed when [Function set] – [Printtabulation]– [Tabulation function] is set to [Valid] .PowerSetup Power Save Enable Setting Valid/Invalid of the save power mode.DisableLanguageSetup LanguageInitialize Execute Deletes the message file in a flash memory.