43856301TH Rev.3 74 /Oki Data CONFIDENTIAL 4. Component replacement4.2.16 Guide eject Assy/ Color resist Assy/ Board-PRY(1) Remove the left side cover, right side cover, rear cover, top cover Assy. (Seesection 4.2.3, 4.2.4, 4.2.6, 4.2.10 )(2) Remove the print engine controller PCB, control PCB and low-voltage powersupply. (See section 4.2.8, 4.2.9, 4.2.15(3))(3) Remove the connector of belt thermistor, remove the two torsion springs , anddisengage four claws (4 places) by minus driver, remove the cover driver .(4) Remove the screws (silver) and connectors (6 places), remove the BoardPRY .(5) Remove the two screws (silver) and remove the color resist Assy .(6) Remove the two screws (silver), remove the cable of fuse I/F connectorfrom clamp, and slide the claw of cable guide to disengage, remove the guideeject Assy .FUSER LCRRCRDENSEXITPUIFClawClaw