- 41 -3. Connecting to a ComputerWireless LAN (AP mode) directly connects wireless devices (computers, tablets,smartphones, etc.) to the machine without using a wireless LAN access point.• If there is metal, aluminum sash, or a reinforced concrete wall between the machine and wireless devices,connections may be harder to be established.• Up to four devices can be connected to the machine via the wireless LAN (AP mode). The fifth device will be rejected.• You cannot enable wireless LAN (infrastructure) and wireless LAN (AP mode) at the same time.Automatic Connection (Push-button)If your wireless devices support WPS-PBC (push button), you can connect to the wirelessLAN (AP mode) with the WPS button.1 Confirm the position of the WPS button on your wireless device by the manualattached to the device.2 Turn on the machine.• If the "Do you want to Set-up wireless?" message appears, select [No (Do not show next time)].3 Press the scroll button several times to select [Wireless(AP Mode) Setting]and press the «ENTER» button.4 Enter the administrator password using the numeric (0-9) keys, and then pressthe «ENTER» button.The factory default administrator password is "123456". If the administrator password ischanged, enter the updated password.5 Press the scroll button to select [Enable] and then press the «ENTER»button.6 Press the scroll button to select [Automatic Setup (PushButton)] and pressthe «ENTER» button.7 Select [Yes], and then press the «ENTER» button.8 Start the WPS-PBC (push button) operation on your wireless device toconnect to the machine.When [Connection successful] is displayed, the setup of the wireless LAN iscompleted.If [Connection failed] is displayed, follow the steps in "Manual Setup" to try again.If connection failed, go to "Manual Setup".Manual SetupIf your wireless devices do not support WPS-PBC (push button), you can enter [SSID] and[Password] of the machine in your wireless devices to connect to the wireless LAN.1 Turn on the machine.2 Press the scroll button several times to select [Wireless(AP Mode) Setting]and press the «ENTER» button.3 Enter the administrator password using the numeric (0-9) keys, and then pressthe «ENTER» button.The factory default administrator password is "123456". If the administrator password ischanged, enter the updated password.4 Press the scroll button to select [Enable] and then press the «ENTER»button.5 Press the scroll button several times to select [Manual Setup] and pressthe «ENTER» button.6 Check the [SSID] and [Password] of the machine.7 Input the machine’s [SSID] and [Password] that were confirmed in step 6 foryour wireless device.Connecting to the Machine Directly (AP Mode)
