45530603TH Rev.2 5-50Oki Data CONFIDENTIAL 5. MAINTENANCE MENUS5.3.2.11 Print counter displayThe print counter display is used for viewing print counter values.1. Enter the self-diagnostic mode and, until PRINTER STATUS appears, pressthe MENU or MENU button. Then press the OK button. (The MENU buttondisplays the next test option and the MENU button displays the preceding testoption)2. Pressing the MENU or MENU button displays the number of printed numberin order.(Pressing the ON LINE or CANCEL button is invalid.)3. Press the BACK button to end the test. (The state is restored to the step 1).Display of consumable continuous counterUpper line ofthe displayLower line ofthe display Format Unit DetailsS1-IMPRESSIONS********PRINTSDEC Prints Displays the number of printed sheets ofeach color (*1)S2-IMPRESSIONS********PRINTSDEC PrintsS3-IMPRESSIONS********PRINTSDEC PrintsS4-IMPRESSIONS********PRINTSDEC PrintsS5-IMPRESSIONS********PRINTSDEC PrintsTOTALSHEET CNT********PRINTSDEC Prints Displays the total number of printed sheets(*1)*1 Two counts apply to the duplex printing.5.3.2.12 Factory-Shipping mode switchingThe Factory-Shipping mode switching is used for switching from the Factory to Shippingmode.1. Enter the self-diagnostic mode and, until the following message appears, pressthe MENU or MENU button.FactoRY MoDe set2. Press the OK button. The following message appears. Press the MENUor MENU button until the option intended (refer to the table shown below)appearsFactoRY MoDesHiPPing MoDe *3. A setting for the option can be selected by pressing the OK button while theintended option is displayed.4. Press the OK button while the intended setting value is on the display. Then, thesetting value is stored in the EEPROM.5. Press the BACK button to end the test. (The state is restored to the step 1)FACTORY MODE Setting ItemsUpper line ofthe displayLower line ofthe display FunctionFACTORYMODEFACTORYMODESets the Factory mode.SHIPPINGMODECancels the Factory mode to enable the shipping mode function.
