2 HOW TO MAKE COPIES36 Bypass CopyingBypass Copying Bypass copyingWhen you make copies on OHP film, sticker labels, Thick 4 paper or non-standard size paper, place copy paper on thebypass tray. Bypass copying is also recommended for copying on standard size paper which is not set in any of thedrawers.If you select the paper size, you can utilize various functions such as the automatic paper selection (APS) or theautomatic magnification selection (AMS). For details, see the following page: P.183 “Copying Function Combination Matrix”The operating procedure for bypass copying differs depending on the paper size to be used. See the table below for theoperating procedure of each size. Bypass copying stops when the paper placed on the bypass tray runs out during copying, even if the paper of thesame size is in any of the drawers. Copying restarts when paper is supplied to the bypass tray. When bypass copying has been completed, the [FUNCTION CLEAR] button on the control panel blinks. Press thisbutton to switch bypass copying to normal copying using the drawers.(Even if you do not press the [FUNCTION CLEAR] button, the bypass copying mode will be cleared when theautomatic function clear mode kicks in after a specified period of time.)Open the bypass tray for bypass copying.If the paper is large, pull out the paper holder.Paper size ProcedureStandard sizeOther than North America:A3, A4, B4, B5North America: LD, LT, LG,ST-R P.37 “Copying on A3, A4, B4 and B5 size paper (in equipment other than forNorth America) / LD, LT, LG and ST-R size paper (in equipment for North America)”Other than the above P.40 “Copying on other than the above standard sizes of paper”Others (Non-standard sizes) P.43 “Bypass copying on non-standard size paper”
