3.BASIC COPY MODESSelecting Finishing Mode 773 BASIC COPY MODES Manual staple modeYou can staple copied paper manually without any copying operation. This is useful when you have forgotten to set thestaple sort mode before starting copying, or when you want to staple originals. (Available only with the Finisher MJ-1101 orSaddle Stitch Finisher MJ-1106)Maximum number of sheets available for manual staplingUse the buttons on the stapling control section of the Finisher (optional) for manual stapling.1 Press the stapling button on the stapling control section.The shutter of the paper exit area is opened and this equipment enters into the manual staple mode.2 Press the stapling position switching button to switch the staple position (front orrear).4 Let go of the paper, and then press the stapling button.Stapling starts. When the stapling position switching lamps start blinking, it means the stapling has finished. Thenremove the stapled paper.Be sure that your hands are away from the paper while stapling is in progress.Finishing the manual staple modeRemove the stapled paper from the lower receiving tray, and then press the stapling button. The shutter of thepaper exit area closes. This means that manual stapling is finished. If no operation is performed for approx. 15seconds, the manual staple mode will be automatically finished.Paper sizePaper weight64 - 80 g/m2(17 - 20 lb. Bond)81 - 90 g/m 2(21 - 24 lb. Bond)91 - 105 g/m 2(25 - 28 lb. Bond)A4, B5, LT 50 sheets MJ-1101: 30 sheetsMJ-1106: 50 sheets30 sheetsA3, A4-R, B4, FOLIO, LD,LG, LT-R, COMP30 sheets MJ-1101: 15 sheetsMJ-1106: 30 sheets15 sheets3 Place paper on the lower receiving tray of the Finisher(optional).Fan and jog the paper well. Place it with its face down.When you staple them at their corner on the front side, place thesheets of paper aligned to the front side. When you staple them on therear side, place the sheets of paper aligned to the rear side.The stapling lamp lights when the paper is properly placed. If itdoes not light, replace the paper.Stapling positionbutton / lampsStaplingbutton / lamp
