231Command Lists List of HP-GL and HP-GL/2 Printer Engine Control CommandsThe meaning of the symbols in the table is as follows.Yes : Indicates commands supported by the Printer.Partially : Indicates commands whose functions are partially supported by the Printer.No : Indicates commands not supported by the Printer.If the Printer receives any non-supported commands, it ignores them. If a command not inthe table is received, a command error results.Command Function SupportedESC.(ESC.Y Printer on command YesESC.)ESC.Z Printer off command YesESC.@ Printer configuration setting command No (1)ESC.A Printer model number output command No (1)ESC.B Buffer space output command No (1)ESC.E Enlargement error number output command No (1)ESC.H Handshake mode 1 setting command No (1)ESC.I Handshake mode 2 setting command No (1)ESC.J Printer engine control command aboard command No (1)ESC.K Printing aboard command No (1)ESC.L Logical I/O buffer size output command No (1)ESC.M Output setting command No (1)ESC.N Output mode, handshake mode enlargement settingcommand No (1)ESC.O Enlargement status output command No (1)ESC.P Handshake mode standard setting command No (1)ESC.Q Monitor mode setting command No (1)ESC.R Reset command No (1)ESC.S Buffer size output command No (1)ESC T Buffer size setting command No (1)ESC.U Flash buffer end No (1)(1) Because serial communication is not supported.(2) Enabled only for binary raster data. For vector data and variable raster data, only color overlap mode is enabled.(3) The fonts of the font numbers specified with the AD and SD commands are printed with the fonts of thefont numbers indicated in the CS command table below.(4) Recognized as EOF.LP-2050/LP-2050-MF User's Manual for Basic Printer OperationBefore Use Basic Operations Menu Functions Authenticationfunction Troubleshooting AppendixChapterChapterChapterChapterChapter12345