237T Command Lists List of D-SCAN Format CommandsThe meaning of the symbols in the table is as follows.Yes: Indicates commands supported by the Printer.No: Indicates commands not supported by the Printer (ignored by the Printer).Category Command Function SupportedName HexadecimalBasicFunctionsDUMMY DATA 0000 Indicates the end of the data for each block. YesDIMTAB 01 Initializes. NoMESSAGE 02 Outputs a message. NoPEN 03 Specifies a pen number. YesPAUSE 04 Pauses printing. NoEOD 05 Indicates the end of drawing. YesINITIAL LOCATION 06 Indicates the initial coordinate location for block 1. YesPARABOLA 07 Draws a parabola. YesPAPER FEED 08 Shifts the subsequent data in the X axis direction. YesSPACING 09 Sets the symbol interval. YesKANJI 10 Writes kanji. YesH SPACE 0E Sets the horizontal space for horizontal kanjiwriting. YesV SPACE 0F Sets the vertical space for vertical kanji writing. YesDUMMY VERB 1F Ignores 1 byte of own data. NoARC 21 to 3F Draws an arc or circle. YesSYMBOL 40 to 7F Writes a symbol. YesPLOT 80 to FF Prints a line segment or moves a coordinate. YesPTN SET 0001 Registers a fill pattern. YesPATRN 0002 Fills the inside of closed polygons. Yes(1/6)LP-2050/LP-2050-MF User's Manual for Basic Printer OperationBefore Use Basic Operations Menu Functions Authenticationfunction Troubleshooting AppendixChapterChapterChapterChapterChapter12345
