Getting started > 23S LEEP MODEYour machine transitions from power saving mode to sleep mode after a set period of time.In sleep mode the power consumption of the device in minimal. To cancel or initiate sleepmode, press the Power Save button on the control panel.NOTEThe machine will not enter sleep mode if an error occurs and the machinerequires attention.By default, the time interval to enter sleep mode is set to 30 minutes. Referto “Sleep Time” on page 187.You can enable or disable sleep mode. Refer to “Sleep” on page 189.> When the network connection is switched from wired to wireless, sleepmode is disabled. To enable sleep mode for devices connected usingwireless LAN, enable sleep mode from the sleep mode setting menu.(MC342dw, MC362w, MC562w, MC562dw, ES5462dw MFP, MPS2731mconly)> When a device using the wireless LAN connection goes into sleep mode, thewireless LAN connection is broken. To reconnect to the wireless LAN, pressthe power save mode on the device to recover from sleep mode.(MC342dw, MC362w, MC562w, MC562dw, ES5462dw MFP, MPS2731mconly)> After the device connected to the wireless LAN has recovered from sleepmode, it automatically connects to the wireless access point using the samesettings as before it went into sleep mode. However, it may take up to1 minute to connect. (MC342dw, MC362w, MC562w, MC562dw, ES5462dwMFP, MPS2731mc only)> When the network connection is switched from wireless LAN to wired LAN,sleep mode is enabled. (MC342dw, MC362w, MC562w, MC562dw,ES5462dw MFP, MPS2731mc only)> Depending on your network environment, your computer may wake fromsleep mode immediately. If this happens, it is recommended that youdisable sleep mode.
