45376001TH Rev.1 39 /Oki Data CONFIDENTIAL 2. Operating instructions2.3.1.3 Fundamental operationsDrive force trasmission diagramThe MFP is a document feed device of skim reading only.Drive force diagram of the MFP is shown below.[1] ADF Relation board(7RL) [6] Feed and transport motor drive signal[2] Document detection signal [7] Document set signal[3] Document detection signal [8] Feed clutch signal[4] Regist clutch signal [9] Document set signal[5] Document detection signal [10] Gear change solenoid signal㻹㻯㻸㻝㼇㻝㼉㼇㻞㼉 㻔㻿㻯㻺㻕㻼㻵㻝㻝㼛㼚㼑㻌㼣㼍㼥㻯㻸㻞㻿㻸㻼㻵㻝㻞 㼇㻟㼉 㻔㻾㻱㻳㻕㻼㻵㻝㻟 㼇㻡㼉 㻔㻾㻱㼂㻕㻔㻯㻸㻞㻕㼇㻠㼉㼇㻢㼉 㻔㻼㻹㻕㼇㻣㼉㻼㻵㻝㻠 㻔㻴㻻㻼㻕㻔㻯㻸㻝㻕㼇㻤㼉㼇㻥㼉㻼㻵㻝㻡 㻔㻿㻱㼀㻕㻔㻿㻸㻕㼇㻝㻜㼉Overview of operation modesThere are four operation modes that are executed by the MFP. The respective operationmodes are executed in accordance with the instructions given by the connected equipmentto implement the print operation.Name of the operation modes, the overview of the operation and the corresponding printmodes are shown in the following table.Name of the operationmodesOverview of theoperation Supporting print modes[1] Normal directionfeed paper/UnloadpaperDocument is fedand scanned.Upon completion ofscan, document isunloaded as it is.Single-sided document → Single-sided printSingle-sided document → Both-sided print(This operation is performed in both caseswhen documents of same width and differentwidth are used.)[2] Normal directionfeed paper/Inverted unloadpaperDocument is fedand scanned. Uponcompletion of scan,document is invertedand unloaded.Both-sided document → Both-sided printBoth-sided document → single-sided print(This operation is performed in both caseswhen documents of same width and differentwidth are used.)
