Oki MICROLINE 385/6 Handbook

MiscellaneousCarriage return Decimal Hexa-decimal:ASCII c<Carriage return 13 OD CR E FWhen it receives this command, the printer will print data from the print buffer athe printing position to the beginning of the line. If Auto Line Feed is ON in the rprinter adds a line feed to each carriage return. This command cancels one-lirwidth printing.Backspace Decimal Hexa-decimal ASCII C<Backspace 8 08 BS E FThe backspace command prints any data that is in the print buffer and moves theone character to the left. The actual width of the backspace depends on the curiIf you are using proportional spacing, the BS command moves the printhead 1/the left.Reset Decimal Hexa-decimal ASCII GReset (Initialise printer)or27 6428 641B 401С 40ESC @FS@EEEpsonThis command removes any data in the printer's buffer and returns the printer to ttmenu settings. It will override any features set on the printer's front panel. This is ainitialisation. If Reset Inhibit is YES in the menu, these commands will be ignorMany software packages send the reset command to initialise the printer beforprinting. This is done to make sure that settings from a previous print job do not accarry over into the next one. However, this could interfere with settings you havethe control panel or through control codes.If your software lets you add or modify initialisation strings (also called setup strican eliminate reset commands you do not want, or add them where you want tthe printer is set to its defaults (the menu settings). Check your software manual 1on modifying initialisation strings.