%4.8.03 Font Test4.8.03 Font TestGeneral InformationThe font test is a one page sample printout of each available typeface.HSD 10 cpiHSD 12 cpiHSD 17.1 cpiUtility 10 cpiUtility 12 cpiUtility 17.1 cpiNLQ 10 cpiNLQ 12 cpiNLQ 10 cpi Double Height / Double WidthAt the top of the test is the printer type (1), emulation (2), country (3), and firmware revision level(4). This information is often required while performing service or when contacting Okidata. Havethis test available during your service call.CAUTIONRunning the test without paper loaded will allow the printhead to print on the platen. This will dirtythe platen, cause excessive wear of the ribbon, and may damage the platen, ribbon, andprinthead.ProcedureFollow these steps to print the font test.1. Load the paper.2. Power off the printer.3. Press and hold the LF switch while powering on the printer. You must hold the LF switch until thetest starts to print.4. The one page test will print, then stop.ML520/521 ( 96-02-04 )
