English884. Remove the old image drum unit (complete with toner), and set itaside on an old newspaper, magazine, etc.5. Remove the new image drum unit from its packaging and place it inthe machine. (Wrap the old unit in the packaging of the new unitbefore throwing it away.)6. To ensure that the image drum is positioned correctly, press downfirmly on both locations of the image drum marked “PUSH”.7. Install a new toner cartridge (see previous instructions for TonerCartridge Replacement).8. Close the cover to the image drum compartment pushing down on ituntil both latches catch.9. Return the document tray to its working position.10. Turn power switch back on.11. After power has been fully restored and the display is functioning,press Menu/Exit to enter Menu.12. Press " to select Counter settings, press ENTER or $.13. Press ENTER or $ to select DRUM COUNT, press ENTER.14. Press CLEAR to reset the drum counter.15. Press MENU/EXIT to return to standby mode.Cleaning scanner pathTo ensure the best possible scanning quality, paper lint and dust should becleaned from the area around the contact image sensor periodically. Toclean the scanner path, open the control panel and gently wipe the areaover the scanner (1) as shown below.5750GB.book Page 88 Tuesday, June 6, 2000 8:08 PM
