English38Note 1: This applies when the Fax2Net service or NIC Card is mounted.Note 2: This step required only if ISDN G4 board is installed. However,this setting is specific to each Speed Dial number and is notaffected by the overall machine ISDN setting (Speed access no.29).Other keys used in the programming process include MENU/EXIT,SHIFT (!"#$) keys, ENTER, Capital (CAPS), CLEAR, and Delete(DEL).Programming speed dial numbers1. Press MENU/EXIT to enter the menu.2. Press " to select LOCATION PROGRAM, press ENTER or $.3. Press ENTER to select SPEED DIAL.4. Enter speed dial number to be programmed (one-touch, 2-digit, 3-digit), press ENTER.5. Enter LOC # (telephone number), press ENTER.6. Enter Name, press ENTER.7. Input ALT# (telephone number), press ENTER.8. Press ! or " to select Communication Speed, press ENTER.9. Press ! or " to select Echo Protection, press ENTER.10. Press ! or " keys to select mode (G4 or G3), press ENTER.Note: This step required only if ISDN G4 board is installed. However,this setting is specific to each Speed Dial number and is notaffected by the overall machine ISDN setting (speed access no.29).11. Repeat the above process from Step 3 until finished programming.When finished, press MENU/EXIT to return the machine to standbymode.Comm. Speed Parameter selection 33.6K / 28.8K / 14.4K / 9.6K / 4.8KEcho Protection Parameter selection ON / OFFG3/G4 Selection Parameter selection G3 mode / G4 mode (see Note 2 below)Entry Description Type of Input5750GB.book Page 38 Tuesday, June 6, 2000 8:08 PM
