Oki PAGE 12i User Manual

Also see for OKIPAGE 12i Series: User guide Brochure & specs User guide User guide User guide

Contents

4. ADMINISTRATING PRINTERS IN NETWORK655 When you see that the bottom column of the LCD is “DISABLE*”,press “t” button or “s” button until “ENABLE” is displayed in theLCD bottom column. Then press “ENTER” button to have the“ENABLE*” displayed. Then, press “ON-LINE” button to end themenu setting.6 If you do not wish to receive print data from the network, set “NET-WORK” to “DISABLE*” in the above procedure.4.2.2 Setting TCP/IPTo use this network card in the TCP/IP protocol, TCP/IP must be set toENABLE on the printer’s operator panel.4.2.2.1 TCP/IP Enable/Disable1 Confirm that the printer is in the idle state from the LCD panel andthe lamp.2 Press “ON-LINE” button to set the printer to OFF-LINE, and holdthe “MENU1” button for 2 seconds or longer, to have “PRINTMODE” displayed.3 Press the “MENU1” button repeatedly, to have the “NETWORK”displayed, and press the “ENTER” button.4 When you see that the bottom column of the LCD of “TCP/IP” is“ENABLE*”, press “MENU1” button to proceed to set “IP BYTE1”.If the bottom column of the LCD is “DISABLE*”, press “t” buttonor “s” button until “ENABLE” is displayed in the LCD bottom col-umn. Then press the “ENTER” button to have “ENABLE*” dis-played (* indicates that that value is set.)4.2.2.2 Setting IP Address1 Following the procedure of the sub-section 4.2.2.1, “TCP/IP En-able/Disable”, press “MENU1” button, to have “IP BYTE1” dis-played.2 Change the address by pressing “t” button or “s” button. (If youhold the button for a several seconds, it will expedite the addressupdating.) When the value to be set is displayed, press the Enterkey to finalize it.3 Press “MENU1” button to move to “IP BYTE2” setting. Set up toand including “IP BYTE4”, in the similar manner to the “IP BYTE1”.