Oki Pacemark PM4410 Setup Manual

Also see for Pacemark PM4410: User guide Installation and setup User guide User guide Information sheet

Oki Pacemark PM4410 Setup Manual Manual pdf 23 page image

E-21Pacemark 4410 Setup GuideLoad PaperFront Feed Continuous FormsPaper Specifications: Front FeedMaximum thickness: 0.031 inches (0.79 mm)Type Weight WidthSingle Part 12 to 24 lb. (45 to 90 g/m2 ) 3* to 16.5 inches (76 to 419 mm)Carbonless 9 to 11 lb. (34 to 41 g/m2 ) 3* to 16.5 inches (76 to 419 mm)(1 + 9 max.)Interleaf 9 to 14 lb. (34 to 52.5 g/m 2 ) 3* to 16.5 inches (76 to 419 mm)(1 + 6 max) 9 lb. (34 g/m 2 ) carbonLabels 0.011 inch (0.28 mm) thick 3¼ to 15 inches (83 to 381 mm)Envelopes 24 lb. (90 g/m 2 ) max. 3 to 10 inches (76 to 254 mm)Card Stock 100 lb. (375 g/m2 ) max. 3 to 8 inches (76 to 203 mm)* For paper widths less than 5 inches (127 mm), remove the support between thetractors.When using paper which is thicker than 7-part carbonless orits equivalent, you must enter the Menu mode, then go to theImpact Mode item in the Set-Up group and select HighImpact Copy as the setting.To load front-feed continuous forms:Preparation1. Position the printer at the front edge of the support (this promotes theunrestricted flow of paper into the printer), then place a stack ofcontinuous forms below the printer. Recommended height of printersupport, 29.5 inches (750 mm).