Olivetti D-COPIA 120D Operation Manual

Contents

Olivetti D-COPIA 120D Operation Manual Manual pdf 30 page image

28Installing onto Windows 95/98/Me/NT4.0/2000(Parallel interface)Before starting the installation, make sure the USB or parallel interface cable is notconnected to the MFP.1 Insert the supplied CD-ROM into your CD-ROM drive.2 Double-click "My Computer" ( ), and then double-click theCD-ROM ( ) icon.3 Double-click the "Setup" ( ) icon.4 Select the software packages to beinstalled, and then click the "Next"button.The software packages with checkmark ( )on the list on the screen will be installed.Click the "Display README" button to showthe information on the selected package.5 The next screen appears. Make sure that the parallel interfacecable is not connected, and click "OK".6 Check the contents of the package on the screen, and thenclick the "Start" button.The software packages to be installed will be displayed on the screen. Ifinappropriate packages are displayed, click the "Back" button to select onlyappropriate software packages.When any of "Hardware Found", or "Found New Hardware Wizard"messages appear during the software installation, be sure to click the"Cancel" button.If the language selection screen appears after you double click the"Setup" icon, select the language you wish to use and click the "Next"button. (Normally, the correct language is selected automatically.)In Windows 95/NT 4.0, "ButtonManager" does not appear. InWindows 98/Me/2000, do not selectthe "Button Manager" checkbox.because this is not supported whenusing the parallel interface.Desktop Document ManagerWindows 95/NT 4.0 Windows 98/Me/2000