Service ManualY100250-4 8-58.4 TAB ADJUSTMENTMACHINE CONDITION:The upper mechanical assembly must be raised.OBJECTIVE ADJUSTMENT:Tab (1) must come into contact with print bar (2), and simultaneously the balancer (3) must come intocontact with the tab support shaft (4).PROCEDURE:Loosen screw (5) and position the parts as explained. Tighten the screw. When adjustment is complete,make sure that the following conditions are met when clearing the gap between the balancer and knob:the tab must be in contact on the entire paper path or at a maximum distance of 0.5 mm from the platen.Fig. 8-4Note: Perform this procedure after adjusting the print bar.IN CONTACT
