9-6 Y100250-49.2.4 PRINTHEAD FLAT CABLE DISASSEMBLY/REASSEMBLY- Remove the printer case (section 9.2.1).- Free the cable clip (1) located on the right-hand side of the frame by unhooking it from the inside (2)of the frame itself.- Remove the soundproofing (3).- Loosen screw (4) that secures the rear cable fastener, rotate the fastener and then free the flatcables.- Rotate the flat cable support (5) connected to the printhead upwards as far as it goes.- Remove the mylar sheet (6) from underneath the flat cable support, then free the flat cables from theirsecuring tabs on the support.1Fig. 9-423456
