1010-10 d-Color MF552/452/362/282/222[Function Display Key (Send/Save)]To display: [Utility] - [User Settings] - [Custom Display Settings] - [Function Display Key(Send/Save)]Change the function key to be displayed in the main screen in the fax/scan mode and the send and save set-ting screens in the User Box mode.Select a function key number, and specify the function to assign.The following shows the default functions.- [Function Key 1]: [Simplex/Duplex]- [Function Key 2]: [Resolution]- [Function Key 3]: [Color]- [Function Key 4]: [File Type]- [Function Key 5]: [Scan Size]- [Function Key 6]: [E-mail Settings]- [Function Key 7]: [OFF]Tips- The above functions can be configured when you are allowed to change a function key by the admin-istrator.[FAX Active Screen]To display: [Utility] - [User Settings] - [Custom Display Settings] - [FAX Active Screen]Select whether to display the screen indicating the machine status during fax transmission.[Search Option Settings]To display: [Utility] - [User Settings] - [Custom Display Settings] - [Search Option Settings]Configure the contents of the search screen when performing an detail search for registered destinations.Settings Description[TX Display] Select whether to display a screen indicating a fax being sent.You can check information on a destination and document in this screen.[No] is specified by default.[RX Display] Select whether to display a screen indicating a fax being received.You can check information on sender and fax being received in this screen.[No] is specified by default.Settings Description[Uppercase and Lower-case Letters]Select whether to distinguish between upper and lower case alphabetcharacters when searching for a registered destination.[Differentiate] is specified by default.[Search Option Screen] If you want to change the setting of [Upppercase and Lowercase Letters]when searching for a destination, select [ON].If you select [ON], the check box for switching the setting is displayed inthe [Name Search] and [Address Search] screen respectively.[OFF] is specified by default.
