3921 Gently half-press the shutterbutton.The camera emits a small beep and theAF correct mark in the lower left corner ofthe viewfinder lights green when thesubject is completely in focus. Keep thebutton pressed halfway and go to Step 2.If the AF correct mark in the lower leftcorner of the viewfinder blinks, the subjectis not completely focused. Release theshutter button, compose the picture againby centering on another part of the picture,and then repeat from Step 1. If you seethe mark blinking, this is the low lightwarning, telling you that you must use thebuilt-in flash. Press the flash button toopen the built-in flash unit.2 Gently full-press the shutterbutton.The picture is taken and the image startsto be stored on the memory card. The cardaccess lamp blinks while the picture isbeing stored on the card.To take another picture, repeat from Step1. While the camera is storing the previousshot on the card, you can take up to 4exposures.Taking pictures without half-pressingYou can take pictures without half-pressing the shutter button. In such cases, the camera startsfocusing when you full-press the shutter button. Therefore it takes a few moments to take a picture,and you might miss a good picture.Low battery warning blinks immediately after taking a shot?Immediately after taking a shot, if you see the low battery warning blink and then light in the controlpanel, the picture may not have been taken correctly. Install a new battery and then play back theprevious shot to confirm that it was stored correctly. ( 46, 137)Card accesslampFlash buttonFull-pressHalf-pressViewfinderLights and emits asmall beep whensubject in focus.Blinks when subject isnot in focus. Neitherlights nor blinks whencamera is in themanual focusingmode.Low light warning.When this markblinks, and flash isrequired.AF target mark
