Omnia Stereo Audio Processor Installation And Operation Manual
Also see for ONE: Installation and operation manualInstallation and operation manual
                                                                                                                            | |
Contents
| 
107Software Update ProcedureSoftware updates for the Omnia ONE are performed over an Ethernet connection using any standard Web Browserand an update file downloaded from the Omnia website. The Omnia ONE contains two software banks and the newsoftware is always uploaded to the inactive bank. This is a safeguard against loss of power or other interruptionduring the update. In this event, the Omnia ONE should still boot into the active bank containing the “old” software(but it is best to avoid interruptions in any case).Special Notes:• When updating an Omnia ONE unit to version 2.0 from version 1.1 or earlier, you must update the unit toversion 1.2 first (using the normal update procedure below), run version 1.2, and then update the unit againfrom v1.2 to v2.0 (repeating the procedure below a second time).• If updating one bank should fail, don't try to update the other bank; update the same bank again.To update the Omnia ONE software proceed as follows:1. Download the Omnia ONE software update file (.oup) from the Omnia website at:http://www.omniaaudio.com/support/updates.htm and save it to a convenient location on your computer.2. Make sure your Omnia ONE’s Network Configuration settings have been entered appropriately for yournetwork (see Network Configuration on Page 80 for details) and connect your Omnia ONE’s Ethernet(Livewire) jack to your Ethernet network using a standard Cat.5 cable or directly to a computer using aCat.5 crossover cable.3. Open a standard Web Browser on your computer and connect to the Omnia ONE by entering:http://xxx.xxx.x.xxx/ in the browser’s address bar where the x’s in the example above are replaced with theOmnia ONE’s IP address. Once connected you should see the Login screen shown below. Enter thePassword (the default is “omnia” – all lower case) and click on the “Login” button. (Or simply press“Enter”)4. The Main Menu should appear. Click on the “Firmware Update” link option.5. The “Confirm Firmware Update” screen should appear with the following warning:“Performing an update requires the controls and meters for the audio processor to be stopped. On-air audiowill not be interrupted during the update. However, a reboot is required to activate the new software, andthis will interrupt the audio. At the end of the process, you will have the option to change the current bootbank (to activate the new software) and reboot or to keep running the current software and reboot later. Doyou want to continue the update process?”If you would like to proceed after reading the warning message, click the “Continue” button and the“Update File” dialog should appear: |
Related manuals for Omnia ONE
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine