Omnia Stereo Audio Processor Installation And Operation Manual
Also see for ONE: Installation and operation manualInstallation and operation manual
                                                                                                                            | |
Contents
| 
74<-Exit Click on this option to return to the Output submenu<-Exit Click on this option to return to the Input/Output menu.AM Options (AM Style Only)<-Exit Click on this option to return to the Output submenu.Polarity ControlsThese controls adjust the polarity for each of the 2 analog outputs separately. The “A” outputrefers to the Left channel output and the “B” output refers to the Right channel output. These arehandy to use instead of swapping pins 2 & 3 on XLR connectors or if the wiring is inaccessible.There are two available settings for each polarity control: “Normal” and “Invert”[ANA A Pol] (Analog Output Polarity for the Left Channel)[ANA B Pol] (Analog Output Polarity for the Right Channel)[AES A Pol] (AES/EBU Digital Output Polarity for the Left Channel)[AES B Pol] (AES/EBU Digital Output Polarity for the Right Channel)[LW A Pol] (Livewire Output Polarity for the Left Channel)[LW B Pol] (Livewire Output Polarity for the Right Channel)[Asym Mod] (Assymetrical Modulation)Asymmetrical positive modulation is possible by adjusting the Asym Mod parameter tosome value other than 100%. This will increase the modulation on positive peaks only.The range of adjustment allows asymmetry up to 150% of the negative modulation value.NOTE: Be sure the output polarity is set / wired properly for your transmitter. If it iswrong, this control can increase negative peaks instead![LPF Freq] (Low-Pass Filter Frequency)This control adjusts the cutoff frequency of the Omnia’s post clipper NRSC-compatiblelow pass filter.Cutoff frequency settings of 4.5, 5, 5.5, 6, 7, 8 and 10 kHz are available. |
Related manuals for Omnia ONE
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine