Chapter 9 Network Connection — Network settings- 175 -Network settingsWireless LAN settingsThis is the setting to connect with the iPhone/iPad or the Android terminal directly or to connect to the wireless access point via wireless LAN.Direct connection ([DIRECT])This is the setting to connect the unit to the iPhone/iPad or Android terminal directly.The unit may restart if necessary when the setting is changed.1 Select the [NETWORK] menu → [DEVICE SEL] → [WLAN].2 Select the [NETWORK] menu → [WLAN PROPERTY] → [TYPE] → [DIRECT].3 Select the [NETWORK] menu → [WLAN IPv4 SETTING] → [DHCP] → [SERVER].When the DHCP server function of this unit is not to be used, select [OFF].4 In the [NETWORK] menu → [WLAN PROPERTY] and [WLAN IPv4 SETTING], set each item as necessary.≥ For the setting items, refer to “Setting items for [WLAN PROPERTY] and [WLAN IPv4 SETTING] when set to [DIRECT]” (l 175).5 Select the SSID of the unit from the SSID list in the iPhone/iPad or Android terminal, and enter the password (encryption key).Display the wireless access point list screen in wireless LAN setting, and select SSID of the unit.≥ Factory setting: The model number of the unit you are using is set. (For example: [AG-CX10], etc.)When the password confirmation screen appears, enter the password (encryption key).For details, refer to the operating instruction of the iPhone/iPad or Android terminal.≥ Factory setting: [01234567890123456789abcdef]6 Close the menu or return to the level of the [NETWORK] menu.7 Check the network connection.Once connected, is displayed on the screen of the unit.∫ Setting items for [WLAN PROPERTY] and [WLAN IPv4 SETTING] when set to [DIRECT]≥ When [DIRECT] is set, the following menu settings are automatically set and cannot be changed:j [WLAN IPv4 SETTING] → [DEFAULT GATEWAY]j [WLAN IPv4 SETTING] → [PRIMARY DNS]j [WLAN IPv4 SETTING] → [SECONDARY DNS]@ NOTE0 The startup time after turning on the power may be longer due to starting of the network.0 When changing the settings of [DEVICE SEL], the changes will not be reflected until the unit is restarted. Also, the setting screen termination may takesome time due to the restart of the network service after the setting is changed.0 Some of the items not included in the table cannot be set.0 [ENCRYPTION] will be fixed to [WPA2-AES].[WLAN PROPERTY] [SSID] Network name of the unit (SSID)(Factory setting: The model number of the unit you are using is set.(For example: [AG-CX10], etc.))[CHANNEL] Channel used(Factory setting: [AUTO])[ENCRYPT KEY] WPA2 encryption key(Factory setting: [01234567890123456789abcdef])[WLAN IPv4 SETTING] [DHCP] Setting the DHCP function≥ [OFF]: Does not use DHCP.≥ [SERVER]: Enables the DHCP server function of the unit.(Factory setting: [OFF])[IP ADDRESS] IP address of the unit(Factory setting: [192.168.0.1])[SUBNET MASK] Subnet mask(Factory setting: [255.255.255.0])
