Chapter 3 Preparation — Preparing the memory card- 36 -Preventing unintentional erasingWriting, erasing and formatting data is prohibited by setting the write-protection switch A of the memory card to the LOCK side.Status of the card access lamp and memory cardCard access lamp Memory card statusOrange (illuminated) Recording target Both loading/writing are permitted. Current recording target.Green (illuminated) Recording possible Both loading/writing are permitted.Orange (flashing) Accessing card Loading/writing are currently being performed.Orange (rapidly flashing) Recognizing memory card The memory card is being recognized.Error An error has occurred. This will flash even if the memory card is notinserted when an error has occurred.Green (slowly flashing) No remaining recording capacity No recording capacity left on the memory card. Only loading is possible.Write-protected The write-protection switch of the memory card is set to the LOCK side.Recording not possibleIt cannot record with the recording format that is currently set. Change therecording format or use a memory card compatible with the recordingformat to record.Off No memory card inserted A memory card has not been inserted.Illegal format It is not the correct format. Reformat the card.Card not supported This is a card that cannot be used with the unit, such as MMC (Multi MediaCard).During card reader mode The card 1 access lamp/card 2 access lamp turns off when not accessing.Off (For the ) Setting to [NETWORK] menu →[NETWORK FUNC] → [NDI|HX]Cannot record and play back. The functions other than recording andplayback (loading of the scene file, etc.) can be used.CX10
