Panasonic AG-HMX100P Operating Instructions Manual

Also see for AG-HMX100E: Operating instructions Operating instructions Operating instructions

Panasonic AG-HMX100P Operating Instructions Manual Manual pdf 20 page image

20Basic OperationSetting ScreenWhen setting up this unit or adjusting functions, you need to check the current settings on the LCD screen.The following shows the basic configuration of the setting screen.POS.MOSAIC SIZEOFF XY 0OFF 0DEFOCUS LEVELOFFMONOEVENTVIDEO EFFECTS CH AME TIME PATTERN INT00 E 2:00 F 3044 WHTX 128Z 196 FAN STOPY 1281 2 354 61 Joystick, rotary Z control settings, and 3D displayareaShows the setting values of the joystick and rotary Zcontrol; X, Y, and Z values during position setting andPB, PR, and C GAIN values during color setting.When this unit is in 3D mode ( page Vol. 2-25), [3D] isdisplayed.2 Audio level meterIndicates the audio output level.3 Error MessageAn error message appears in the following cases.Message Condition and ActionFAN STOP The fan has stopped from any cause.Immediately turn off the power andrequest a service call ( page 39).CHANGE HDMIFORMATCHANGE HDMI1FORMATCHANGE HDMI2FORMATHDMI input source in the format otherthan the system formats ( page 19)available for this unit is beingconnected to this unit.CHANGE HDMI FORMAT: Inputsources of both HDMI INconnectors are in unavailableformats.CHANGE HDMI1 FORMAT:Input source of the HDMI IN 1connector is in unavailable format.CHANGE HDMI2 FORMAT:Input source of the HDMI IN 2connector is in unavailable format.Change the system format setting orthe input source setting. NOTEThe “FAN STOP” error message is also displayed on themulti-view screen. However, since the multi-view screendoes not open when this unit is in 3D mode ( pageVol.2-25), no error message is displayed even if the fanstops. Pay attention to a message which will appear on theLCD.If two types of errors occur at the same time, “FAN STOP”is displayed preferentially.4 Event number, transition time, pattern number, andinternal video display areaEVENT: Shows the event number ( page Vol.2-20).ME TIME: Shows the setting value of transition time( page 35); DSK TIME value during downstreamkey setting ( page 37) and FADE TIME valueduring fade setting ( page 38).To change the TIME type, press the applicabletransition time setting button (ME, DSK, or FADE) toturn on.PATTERN: Shows the number of the currently selectedpattern ( page 35).INT: Shows the type of the currently selected internal(internally generated) video ( page 28).5 Menu title, related information, rotary 1 to 5parameter display areaShows the title of the currently selected menu( page 21) (e.g., VIDEO EFFECTS), bus settings(A/B), related information (color settings, etc), andsetting positions of rotary 1 to 5 controls.