Panasonic AG-HMX100P Operating Instructions Manual

Also see for AG-HMX100E: Operating instructions Operating instructions Operating instructions

Panasonic AG-HMX100P Operating Instructions Manual Manual pdf 32 page image

32Basic Operation3 Set [FRAME] to the number of frames topreview using the rotary 3 control.To preview the movie, select a value equivalentto or smaller than the number of frames of themovie.4 To preview the still picture, select [FRAME](frame display) or [FIELD] (field display) usingthe rotary 4 control.To preview the movie, select [REPEAT] (repeatplayback) or [ONCE] (only-once playback)using the rotary 4 control.5 Press the key.During still picture preview, the still picture on thepage selected in above Step 2 is displayed.During movie preview, the movie contains framesthe number of which is selected in Step 2 is playedback. NOTEUpon save of a still picture or movie, set [MODE] to [EXIT] to•prevent the saved data from being overwritten.If you select [EXIT] during playback of a saved movie and•press the key, the image of the last frame is displayedand the playback of the movie stops.Even if other internal video (back matte or color bar) is•selected in the [INT VIDEO] menu, [MEMORY] can beselected again to call the previously saved still picture ormovie. However, the saved still pictures and movies aredeleted when the power is turned off.To start/stop playback of a movie withoutusing the [INT VIDEO] menu1 Press the . (period) key while holding the SHIFTkey.2 Start playback in the confirmed playbackmethod for internal video.3 To stop playback, press the . (period) key whileholding the SHIFT key again.Using Video Input from PC [PC1]Video can be input from PC to this unit via the DVI-I INconnector.For using video created on PC, it is necessary to allocatethe DVI-I input to an input source number in the [AUDIOVIDEO] submenu of the [SETUP] menu in advance( page 24).The source input from PC is set from the [PC1] submenu ofthe [SETUP] menu.Rotary 1 Rotary 2 Rotary 3 Rotary 4 Rotary 5ANALOGDIGITALXGAWXGASXGA1080/50p1080/60p_ _ONOFFPC1 ANALOG A.SETFORMATSXGA ONTo select the DVI-I IN connector inputSelect [ANALOG] or [DIGITAL] using the rotary 2 control.To select the input signal formatSet [FORMAT] using the rotary 3 control.The source input from PC is displayed in the selectedsignal format. However, it is resized according to thesettings of the video format ( page 26).To execute auto setup of analog inputSelect ON using the rotary 5 control, and press the key.When the message [OK?] appears, press the key again.To cancel the execution, press the key while holdingdown the SHIFT key. NOTEWhen switching is being made between [ANALOG] and•[DIGITAL], the message “Please Wait…” appears, anddisappears upon completion of switching.When auto setup is executed, the image must be shown in•the entire display area of the screen. When auto setup isbeing executed, the message “Please Wait…” appears, anddisappears upon completion of auto setup.If auto setup is not successful, * appears under [A.SET].Auto setup may become unsuccessful due to insufficientautomatic screen adjustment depending on the input image.In this case, use the rotary 1 control to select [PC2] andadjust [H POSI], [V POSI], [PHASE], and [CLOCK].If the system format is 1080/50p or 1080/60p when DIGITAL•or ANALOG is selected, auto setup is disabled. In this case,“---” appears under [A.SET].