Panasonic AG-HMX100P Operating Instructions Manual

Also see for AG-HMX100E: Operating instructions Operating instructions Operating instructions

Panasonic AG-HMX100P Operating Instructions Manual Manual pdf 34 page image

34Basic Operation NOTEIf the AUDIO FOLLOW VIDEO button has been pressed to turnon to interlock the audio faders with the transition lever or theaudio level of input source 5 to 8 has been adjusted with theSHIFT key pressed, the audio fader settings may not match theactual audio level.In such a case, the audio level is adjusted as follows accordingto the operation of the audio faders:When the audio fader is moved in the direction in which a•difference with the actual audio level decreases, the audiolevel does not change until the fader position matches theactual audio level.When the audio fader is moved in the direction in which a•difference with the actual audio level increases, the audiolevel changes according to the fader position.The audio level adjusted by the MASTER fader changes•according to the fader position.AB TransitionAB transition is an effect of switching from source video Ato source video B, and vice versa.There are two methods of video switching: “wipe” and“mix.”Transition wipe•Source video B (or A) appears by wiping out sourcevideo A (or B).Transition mix•Source video B (or A) appears by overlapping sourcevideo A (or B).The following diagram shows an example of transition wipe.Transition is executed with the transition lever or the AUTOTAKE button.1 Set [TYPE] to [AB] in the [BUS] submenu of the[SETUP] menu ( page 27).2 Select source video A and source video B( page 33).3 Slide the transition lever to the A side (or Bside).4 Select the transition pattern to use ( “To selecta pattern” on page 35).Patterns registered as direct patterns ( page 23)can be used.5 Process the selected pattern by applyingeffects including border, shadow, and trail( page Vol.2-3).6 Set the pattern position (transition startposition) using the joystick.Press the CENTER button to turn on, and the patternposition is set to the center.Press the HOLD button to turn on, and the joystick isfixed to the current position. NOTEThere are some patterns for which the position•cannot be adjusted with the joystick. For more information, refer to “List of TransitionPatterns” at the back of Volume 2.For the patterns registered as direct patterns, the•settings of the effects or position applied to eachpattern are saved in memory and applied when thepattern is called next time (if [MODE] in the [SETUP]menu is set to [PRESET]). Any settings made for thepatterns not registered as direct patterns are notsaved in memory.7 Set the transition time (from switching start toend) ( “To set the transition time” on page 35).8 Slide the transition lever to the B side (or Aside) or press the AUTO TAKE button.When the AUTO TAKE button is pressed, it is lightedand the source video switching is automaticallyexecuted (auto transition) from A to B (or B to A).To temporarily stop auto transitionPress the AUTO TAKE button again.This button flashes and the video switching is paused.When the button is pressed again, it is lighted and theswitching is resumed.To limit the transition to one directionWhen the ONE WAY button is pressed to turn on in thePATTERN area, the transition goes in the same directionregardless of the direction in which the transition lever ismoved. (No transition is reversed.)However, if a transition pattern which is not reversedintrinsically is selected, the ONE WAY button flashes whenit is pressed.To synchronize the audio faders to thetransition leverPress the AUDIO FOLLOW VIDEO button to turn on.