Panasonic AG-HMX100P Operating Instructions Manual

Also see for AG-HMX100E: Operating instructions Operating instructions Operating instructions

Panasonic AG-HMX100P Operating Instructions Manual Manual pdf 35 page image

35Basic OperationTo select a patternThe currently selected pattern number is shown in theevent number, transition, pattern number, and internal videodisplay area of the setting screen (PAGE PATTERN00011 Press the PATTERN button to turn on.2 Set the pattern number by entering a numericvalue with the numeric keys or using the + and− keys.3 Press the key.NOTEIf the number with no corresponding pattern (invalidnumber) is specified, the nearest valid pattern numberappears.To set the transition time4HECURRENTLYSETTRANSITIONTIME-%4)-% ISSHOWNINthe area where the event number, transition time, patternnumber, and internal video are displayed on the settingscreen (PAGE The factory default setting is [02:00F] [2 seconds].ME TIME02:00FThe maximum value that can be set is [33:09F=I P I OR;F=I P I FORTHETIMEDISPLAYFORMhSECONDS FRAMESvAND;F]FORTHETIMEDISPLAYFORMhFRAMESv NOTEEven if a value exceeding the maximum value is selected, themaximum value is automatically set.1 Press the ME setting button to turn on.2 Set the transition time by entering a numericvalue with the numeric keys or using the TIMErotary control.Example: To set “2:05” (2 seconds 5 frames),enter “2.5.”4HE;3934%-=SUBMENUOFTHE;3%450=MENUCANbe used to select the transition time display formhSECONDS FRAMESvORhFRAMESvPAGE6OL 3 Press the key.Program Preset TransitionProgram preset transition is an effect of switching fromPROGRAMVIDEOBASEVIDEO TOPRESETVIDEOVIDEOUSEDASANEFFECT ANDVICEVERSA)TISEXECUTEDINTHESAMEMETHODASDESCRIBEDINh!"4RANSITIONvEXCEPTFORSETTING;490%=TO;02'02%=IN3TEP4HE/.%7!9BUTTONISDISABLEDBECAUSEITLIMITSTHEswitching direction only from preset video to program videoTHEBUTTONmASHESWHENPRESSED  NOTEDuring program preset transition, the buses are switched toeach other every time transition is carried out.This state of bus switching can be checked with lighting andflashing of the ME PVW button.When the buses are in the same state as the initialization,the ME PVW button is lighted. When transition is carried outonce and the bus source is switched to the other, the ME PVWbutton flashes.Keying+EYINGISACOMBININGEFFECTOFADDINGSOURCEVIDEO"ASAhKEYvTOSOURCEVIDEO! ANDVICEVERSA4HEKEYINGMETHODSINCLUDEDTHEBASICPATTERNKEY(PAGE6OL CHROMAKEYPAGE6OL LUMINANCEKEYPAGE6OL ANDTITLEKEYPAGE6OL The following diagram shows an example of the basicPATTERNKEY+EYINGISEXECUTEDWITHTHETRANSITIONLEVEROR!54/4!+%button.1 Select source video A and source video B( page 33).2 Slide the transition lever to the A side (or B side).3 Select the key pattern to use ( “To select apattern” on this page).Patterns registered as direct patterns (PAGE can be used.4 Process the selected pattern by applyingeffects including border, shadow, and trail( page Vol.2-3).