Panasonic AG-HVX200PJ Operating Instructions Manual

Contents

Panasonic AG-HVX200PJ Operating Instructions Manual Manual pdf 46 page image

46Adjusting the volume while shootingPAGE/AUDIO MON/VARIf you are monitoring the sound throughheadphones while shooting, you can adjust thevolume with the PAGE/AUDIO MON/VAR button.• To adjust the recording level (Page 54)Backup recordingIf you have connected equipment to the 1394terminal (pages 78 and 79), you can makeautomatic backup recordings of whatever you areshooting.• In the setup menus, OTHER FUNCTIONSscreen, 1394 CONTROL and 1394 CMD SEL,select how to control the equipment you haveconnected. (Page 115)• Select the settings below for the following itemson the DISPLAY SETUP screen (page 113) forbackup recording when using a tape.• OFF for VIDEO OUT OSD• OFF for DATE/TIMENote the following when backup recording.• When performing backup recording while a tapeis used:• If either of the following settings have beenselected, the OSD will be output to the 1394output at all times except when the unit is inthe recording mode.- When ON has been set for the VIDEO OUTOSD option on the DISPLAY SETUP screen(page 113)- When a setting other than OFF has beenselected for the DATE/TIME option on theDISPLAY SETUP screen (page 113)• Bear in mind that the OSD may be recordedinadvertently if backup recording is performedwhen a setting other than OFF is selected forthe 1394 CONTROL option (page 115) on theOTHER FUNCTIONS screen.• If the DATE/TIME button on the remote controlis pressed, the date and time will be outputto the 1394 output regardless of whetherrecording is underway or the recordingstandby status is established.• Menu settings are retained even if you turn thepower off. So if you use the camera-recorder withthe settings for backup recording still in effect,images on media in any unit that connected maybe overwritten. After backup recording, checkthe menu item settings before you operate thecamera-recorder.• If you use another AG-HVX200 as the externalunit for backup recording, select “OFF” for 1394CONTROL on the external unit and set it to MCR/VCR mode.• Backup recording may not work properly if youconnect two or more external units.• Use a DV (IEEE1394) cable of 4.5 m or less forconnection.• Set the external unit up to receive 1394 signalsbefore backup recording.• You can have a media in the external unit startrecording automatically when the media in thisunit is almost finished. Set 1394 CONTROL(page 115) to “CHAIN”.• Note that images are recorded even when youperform a rec check if a P2 card is being used:When a tape is used, no images are outputduring rec check.• You cannot perform backup recording when theunit is set up for native recording.• Backup recording does not work in three ofthe special recording modes of the P2 card:Interval recording, One-shot recording and Looprecording. (Pages 48 - 50)• Backup recording does not work during directshooting (page 67) in MCR mode.Adjusting the volumeShooting techniques for different targets (continued)