Panasonic AG-HVX200PJ Operating Instructions Manual

Contents

Panasonic AG-HVX200PJ Operating Instructions Manual Manual pdf 59 page image

Shooting594 Press the mode button to switch to the VCRmode. (Page 64)5 When rewind or fast-forward the tape, itstops automatically near where you resetthe counter.During dubbing, reset the counter value at theOUT point to stop dubbing with memory stopmode. (Page 82)1394TC preset modeWhen shooting using a multi-camera, you cansynchronously set the initial values of TC.The camera used for synchronization is theMASTER and the camera being synchronized isthe SLAVE.1 Connect a second camera with a 1394 cableand turn both cameras on.• For connection (Page 79)2 Put the MASTER camera in CAMERA modeand output a video signal from the 1394terminal.• Set both cameras to the same recordingformat.Do the remaining steps on the SLAVE camera.3 Switch the SLAVE camera to MCR/VCR mode, set 1394TC REGEN on theRECORDING SETUP screen of the setupmenu to OFF (and, in the case of a tape, setFIRST REC TC to PRESET mode as well),and then set the counter so that it showsthe TCG display.• You cannot do this if you have selectedREGEN.4 In the setup menus, RECORDING SETUPscreen, set 1394 IN PRESET to ON. (Page 109)• 1394TC appears on the screen.5 Stop or eject the media.6 Press the COUNTER RESET/TC SET button.The TCG value is preset with the TC valuefrom the input 1394 signal.• “TC SET OK” is displayed for about 2 secondsin the center of the screen.7 Reset the SLAVE camera to CAMERA mode.Counter display (P2 card / Tape)You can display a counter that indicates how muchtime has elapsed during shooting or playback.1 Press the COUNTER button.Each time you press the button, the displaychanges as follows. (Page 91)0 : 00. 00Counter valueIn the P2 mode, the counter is not displayedduring playback.M 0 : 00. 00 (Tape only)Counter value in memory stop modeTC XX:XX:XX:XXTime code value (Display time code framedigits in 24 frames when 720/24PN is set, andin 30 frames when any other format is set.)tc XX:XX:XX:XX (P2 card only)During recording and playback when FILMCAM has been set under OPERATION TYPE,the time code frame digits are converted into24 frames for display. However, “tc” does notappear during recording when 720/24PNhas been set under REC FORMAT, or duringrecording and playback when 720/30PN hasbeen set.During playback when 720/24PN has been set,the time code frame digits are converted into30 frames for display. (Pages 101 and 107)UB XX XX XX XXUser informationFR --- -Frame rate (30P/24P/24PA) and framesequence in progressive mode shooting.No display:Data is not displayed.Resetting the counterPress the COUNTER RESET button while thecounter is displayed.Memory stop mode (Tape)After shooting or playback, the tape can first bereturned to near the pre-programmed position, andthen stopped automatically.1 Press the COUNTER button to display thecounter in memory stop mode.2 At the desired position on the tape, pressthe COUNTER RESET button to reset thecounter.3 Proceed with playback or shooting.Using the Counter