Displays91Regular displaysScreen displays1 Time code displaysEach time you press the COUNTER button, thedisplay switches over to the following data (orno indication).COUNTER: (Tape or P2-camera mode only)Counter valueM COUNTER: (Tape only)Counter value in memory stop modeTC:Time code value. When the time code valuecould not be read correctly from the P2 cardor the tape, [TC∗] is displayed.When it acts in drop frame mode, the colonbetween seconds and frames become “.”.tc: (P2 card only)Time code value. (During FILM CAM mode,the frame digits are displayed in 24 frames)When the time code value could not be readcorrectly from the P2 card, [tc∗] is displayed.When it acts in drop frame mode, the colonbetween seconds and frames become “.”.UB:User informationWhen user information could not be readcorrectly from the P2 card or the tape, [UB∗]is displayed.FR:Frame rate information for recordingFR 60I : Standard (60i interlace) mode (60fields/sec.)FR 60P : 60P progressive mode (60 frames/sec.)FR 30P : 30P progressive mode (30 frames/sec.)FR 24P : 24P progressive mode (24 frames/sec.)FR 24PA : 24P advanced modeWhen in FR24P and FR 24PA mode, thesequence information of the frame conversionat the final place.2 WarningsREMOTE:Blinks when the wrong equipment setting isselected on the remote control unit.:Lights when condensation has formed insidethe camera-recorder.:Blinks when cylinder heads are dirty.P2 or :Blinks when a P2 card or tape has not beeninserted, or when the camera is in a write-protected state.P2 FULL or END:Blinks when either there is no remainingcapacity in the P2 card or the tape hasreached the end.P2 LACK:Blinks in the loop rec mode when theremaining capacity of the P2 card isinsufficient.:Lights when the internal battery for thecalendar has run out. (Page 60)For details on the safety zone, refer to 36.(Continued on the next page)
