Panasonic AJ-HDC27A Operating Instructions Manual

Also see for AJ-HDC27AP: Operating instructions

Contents

Panasonic AJ-HDC27A Operating Instructions Manual Manual pdf 81 page image

81HIGH SETTING screenThe high level gain is set on this screen.Item Variablerange RemarksMASTER GAIN –3dB:12dB:30dBVFdisplayUSERENG–6dB, –3 dB, 0 dB, 3 dB, 6dB, 9 dB, 12 dB, 18 dB, 24dB or 30 dB can be set.H. DTL LEVEL 0:12:63USERENGFor setting H.DTL (detail)level.V. DTL LEVEL 0:16:63USERENGFor setting V.DTL (detail)level.DTL CORING 0:5:15USERENGFor setting DTL coring.H. DTL FREQ 0:22:29USERENGFor selecting H.DTLFREQUENCY.LEVEL DEPEND 0:5USERENGFor setting LEVELDEPEND.The detail of only the darkareas is removed whenthe Y detail is boosted.The higher the figure setfor this item, the broaderthe range of the detailwhich is removed.MASTERGAMMA0.35:0.45:0.75USERENGMaster gamma setting.(0.01 step)BLACKSTRETCHONOFFUSERENGFor setting the mode tocompensate for low-brightness black stretch toON or OFF.MATRIX TABLE ABOFFUSERENGFor selecting the colorcorrection matrix table.COLORCORRECTIONONOFFUSERENGFor setting the 12-axisindependent colorcorrection to ON or OFF.The underlining in the variable range column indicates the setting in the preset mode.Setting menu screens (CAM MAIN MENU 1)ADDITIONAL DTL 1 screenThe special detail features of the camera are set onthis screen.Item Variablerange RemarksKNEEAPERTUREONOFFVFdisplayUSERENGFor setting the kneeaperture to ON or OFF.At the “ON” setting, thedetail above the kneepoint is boosted.SLIM DTL ONOFFUSERENGFor setting the mode tomake the detail finer toON or OFF.ADDITIONAL DTL2 screenThe special detail features of the camera are set onthis screen.Item Variablerange RemarksKNEE APA LVL 05VFdisplayUSERENGFor changing the detaillevel in the high-brightness areas.DTL GAIN (+) –31:+00:+31USERENGFor changing the H detaillevel in the “+” direction.DTL GAIN (–) –31:+00:+31USERENGFor changing the H detaillevel in the “–” (bottom)direction.DTL CLIP 00:47:63USERENGFor changing the clippinglevel of the detail signal.DTL SOURCE (G+B)/2(R+G)/2(2G+R+B)/4(3G+R)/4RGUSERENGFor setting the ratiobetween the RGB signalcomponents whichgenerate the detail signal.V DTL FREQ. 360TV450TV540TV630TV720TVUSERENGFor setting the V. DTLFREQUENCY.