12Setup MenusBASIC menuThe underlining indicates the factory setting.005 SUPER00000001OFFONFor selecting whether the time code and other displays are to besuperimposed on the monitor (which has been connected to the HD SDIOUT3 or SD SDI OUT3 connectors).0: The displays are not superimposed.1: The displays are superimposed.[ [006 DISPLAY SEL000000010002TIMET&STAT&S&MFor selecting what is to be superimposed on the monitor (which has beenconnected to the HD SDI OUT3 and SD SDI OUT3 connectors).0: Time only1: Time and operation mode2: Time, operating mode and modeO The mode display accords with the format as shown below: DVCPRO (HD) 5 DVCPRO_HDO When T&S&M has been selected and a warning occurs, the informationof the warning will be displayed.For further information, refer to “Warning messages and DIAG display.”[ [007 CHARA H-POS 0000:0006:00370:6:37For setting the horizontal position of the superimposed characters.While this item is being set, the superimposed display is output from theHD SDI OUT3 or SD SDI OUT3 connectors in accordance with thesettings selected for DISPLAY SEL and CHARA TYPE even if OFF hasbeen selected as the SUPER setting. However, it will be in accordancewith the SUPER OFF or ON setting when the menu setting mode hasbeen exited.[ [008 CHARA V-POS 0000:0023:00320:23:32For setting the vertical position of the superimposed characters.While this item is being set, the superimposed display is output from theHD SDI OUT3 and SD SDI OUT3 connectors in accordance with thesettings selected for DISPLAY SEL and CHARA TYPE even if OFF hasbeen selected as the SUPER setting. However, it will be in accordancewith the SUPER OFF or ON setting when the menu setting mode hasbeen exited.[ [009 CHARA TYPE00000001WHITEW/OUTFor selecting the type of characters used to display the superimposing,setup menus, etc.0: White characters on a black ground.1: White characters with a black border.[ [020 SYS FORMAT000000011080i720pFor selecting the HD format to be handled by the unit.0: The 1080i format is selected.1: The 720p format is selected.[ [Item SettingNo. Superimposeddisplay No. SuperimposeddisplayDescription of settingENCDEC031 OUT REF0000000100020003AUTOINPUTHD_REFSD_REFFor selecting the SDI output reference signal.0: When the HD REF signal is input, this signal is used as the referencesignal. When the HD REF signal is not input and the SD REF signal isinput, SD REF is used as the reference signal.When neither the HD REF signal nor the SD REF signal is input, theSDTI signal is used as the reference signal.When HD REF, SD REF or SDTI signals are not input, the internal syncsignal is used as the reference signal.1: When the SDTI signal is input, the SDTI input is used as the referencesignal.2: The signal which has been input to the HD REF IN connector is usedas the reference signal.3: The signal which has been input to the SD REF IN connector is usedas the reference signal.[
