Chapter 4 Adjustments and settings for recording384-7-2 Viewfinder screen status displayconfigurationAll the items that can be displayed are laid out inside theviewfinder as shown in the figure below.4-7-3 Selecting the viewfinder screendisplay itemsTo select which items are to be displayed on the viewfinderscreen, perform menu operations to open the INDICATOR1> screen or screen from theVF page, and select ON or OFF for the display or select thetype desired for each item concerned.For details on operation, refer to “4-6-2 Basic menuoperations.”#< VF INDICATOR1 >EXTENDER :ONSHUTTER :ONFILTER :ONWHITE :ONGAIN :ONIRIS :S+IRISCAMERA ID :BARID POSITION :UPPER LDATE/TIME :OFFZOOM LVL :ONCOLOR TEMP :ON#< VF INDICATOR2 >TAPE :ONBATTERY :ONAUDIO LVL :ONTC :OFFVTR WARNING :NORMALSAVE LED :SAVEFor details, refer to the following pages.4-7 Viewfinder screen statusdisplaysNot only the images but the lamps and characters indicatingthe unit’s settings and operation statuses as well as themessages, center and safety zone markers, camera ID andother information are displayed inside the viewfinder.4-7-1 Viewfinder lamp displaysViewfinder pictured hereis the AJ-HVF20BP.(For details concerningviewfinder, refer to theoperating instructions ofeach viewfinder.)1 TALLY/REC (recording) lampThis lights up (red) during recording. It flashes when aproblem has occurred. For details, refer to the appropriatesection in “6-3 Warning system.”2 (abnormal operating status warning) lampThis lights when the unit is set to an abnormal operatingstatus for any of the items set to “ON” on the “!LED” screenof the setting menu.For details on selecting the items which are to be indicatedwith the lamp, refer to the screen items in“Chapter 7 Menu description tables.”3 BATT (battery) lampThis starts flashing when the battery voltage has droppedto the level where the battery will no longer be usable inseveral minutes’ time, and it lights when the battery is nolonger usable. To prevent operation from beinginterrupted, replace the battery before it has dischargedcompletely. For details, refer to the appropriate section in“6-3 Warning system.”4 VTR SAVE (VTR power-saving) lampThis lights when the VTR SAVE/STBY switch is set toSAVE. It goes off during recording.In the rec-pause mode, the SAVE mode is establishedautomatically, and the lamp lights after the time set for thepause timer (temporary stop time) has elapsed.After two minutes in the play-pause mode, the SAVE modeis established automatically, and the lamp lights./34min DIGITAL14-- GAIN -- -- USER SW GAIN --LOW : 0 S.GAIN:30/36/42/48MID : 9HIGH:18 DS.GAIN: 6 /10 /12/15 /20UM:S.GAIN 30U1:AUDIO 1 FRNT U2:DS.GAIN 6REC WARNING IDTCG 00:00:00:00 iRECM 6 F:1---- ---+ 23h59m1A A 18 F:2---- ---+ ++F14 Z99dB:.dB:∫∫: : :1/250 S DZ ∑10min REC14.6VEX2 32K a2: :.1345 6AB@?>=<;:9CD7EFG JI H2TALLY / RECBATTVTRSAVE14328
