Chapter 5 Preparation585-1 Supplying the powerA battery pack or an AC power source can be used as thisunit’s power supply.To use the battery pack, there is the followingchoice of makes of batteries:≥Panasonic≥Anton-Bauer≥IDX≥PACO≥Sony≥ Batteries of other makes can also be supported by changingthe setting menu but no guarantees are made for thesystem when they are actually used with this unit.≥ Before using the battery pack, recharge the battery usingthe battery charger.(For details on the recharging method, refer to the operatinginstructions of the battery concerned.)5-1-1 Attaching the battery and setting thebattery typeUsing the Anton Bauer battery pack1 Attach the battery pack made by Anton Bauer.2 Insert the battery pack and slide it in the direction of thearrow.Battery pack madeby Anton BauerA battery holder made by Anton Bauer is equipped with apower output connector for the lighting and a lighting controlswitch to enable a light to be easily attached. For details onthe lighting systems available, contact Anton Bauer.3 Set the battery type.Select the battery type using the BATTERY SELECTmenu item. This item is selected from the screen on the VTR FUNCTION page.For details, refer to “7-8-3 BATTERY SETTING1.”Anton Bauer batteries which can be usedO DIONIC90O DIONIC160O HYTRON50O HYTRON100O HYTRON120O PRO14O TRIM14Use the DIONIC80 at the DIONIC90 setting.To remove the battery pack, slide it in the opposite direction tothe one in which it was attached while keeping the releaselever on the battery holder pulled down all the way.Release lever#< BATTERY/TAPE >BATTERY SELECT :PRO14EXT DC IN SELECT :AC-ADPTBATT NEAR END ALARM :OFFBATT NEAR END CANCEL:ONBATT END ALARM :ONBATT REMAIN FULL :70%TAPE NEAR END ALARM :ONTAPE NEAR END TIME :2minTAPE END ALARM :ONTAPE REMAIN/∫ :3min/∫Power output connector for lightingLighting controlswitch
