64 (E)CONTENTSH04F LOADINGDisplays the number of times front loading hasbeen performed in single units.$ Displaying the “HOURS METER”informationTurn the search dial to move the cursor (2).The description for the item where the cursor islocated is shown on the counter display.If “T&S&M” is selected in the setup menu No. 008(DISPLAY SEL), a message appears in the modedisplay whenever a warning or error occurs. Whenmultiple events occur, the event with the highestpriority is displayed.O The resettable items in the “HOURS METER”information are reset by the shop when performingmaintenance or other work.O The search buttons and the search dial cannot beoperated while the DIAG menu is displayed.Error messagesNo./Item DescriptionSer222222222Displays the unit’s serial No.Priority Display/DescriptionHighLowError messages (See error message table)When an operational malfunction has occurred inthe unit, the error number flashes and the errormessage is indicated on the counter display.INT SGWhen SG has been selected as the input signal withthe INPUT SELECT buttons, pressing the RECbutton or the EDIT button (E-E mode) will display“INT SG” for the first two seconds.This is also displayed for the first two seconds whenstarting editing.NO INPUTIf there is no input signal (except for analogue audio)to the connector selected using the INPUT SELECTbuttons, pressing the REC button or the EDIT button(E-E mode) will display “NO INPUT” for the first twoseconds.This is also displayed for the first two seconds whenstarting editing.Warning messages (See error message table)When a warning occurs in this unit, the error numberand warning message are indicated on the counterdisplay.When multiple warnings occur, the warning with thehighest priority is displayed.H00OPERATIONDisplays the time that the power has beensupplied in one-hour units.H01DRUM RUNDisplays the time that the drum has beenrotating in one-hour units.H02TAPE RUNDisplays the time that the tape has been runningduring FF, REW, PLAY, SEARCH (JOG, SLOW,SHTL), REC, and EDIT modes (except for STILLin the JOG, SLOW or SHTL mode) in one-hourunits.H03THREADINGThe number of times for threading (loading)/unthreading (unloading) is displayed in singleunits.H11DRUM RUNrDisplays the time that the drum has beenrotating in one-hour units. (Can be reset)H13THREADINGrThe number of times for threading (loading)/unthreading (unloading) is displayed in singleunits. (Can be reset)H30POWER ONThe number of times the power has been turnedon is displayed in single units.H12TAPE RUNrDisplays the time that the tape has been runningduring FF, REW, PLAY, SEARCH (JOG, SLOW,SHTL), REC, and EDIT modes (except for STILLin the JOG, SLOW or SHTL mode) in one-hourunits. (Can be reset)H14F LOADINGrDisplays the number of times front loading hasbeen performed in single units.(Can be reset)$ UMID information displayThis is displayed when UMID information is presenton the input signal in E-E mode.This lamp lights during tape playback when UMIDinformation has been recorded on the tape.“NO-INFO” is displayed when there is no UMIDinformation.Item Display/DescriptionMATNO Material numberCOPY Instance number (No. of copies)OWNR Country, organization, userPOS Reception status from GPS satellites whenrecording spatial coordinates (height above sealevel, longitude and latitude):HOLD: No reception from any satellite2D: Reception possible, but number ofsatellites is insufficient. Height abovesea level will not be accurate.3D: Good receptionDTAE DateTIME UTC (Coordinated Universal Time) and timedifference with UTC
