5944-10 Handling dataSetting Data Using an SD memory cardAn SD memory card (optional accessory) can be used as asetup card that stores up to eight files of settings menuspecifications.This data allows you to quickly reproduce an optimum state.Regarding SD memory cards, please see memory cards> (page 18).4-10-1 Handling SD memory cardsAn SD memory card may be inserted or removed, either beforeor after the power is turned on.To insert an SD memory cardOpen the lid of the switch cover, and insert an SD memory card(optional accessory) into the SD memory card slot with the notchupward. Close the lid.An SD memory card must be inserted with the right side facingthe slot. If the card is hard to insert, it may be reversed or upsidedown. Do not force it into the slot. Check the card before re-inserting it.To remove the SD memory cardOpen the lid of the switch cover, and ensure that the BUSY lampis not illuminated. Then, further depress the SD memory cardtowards the main unit. This releases the SD memory card fromthe insertion slot. Take hold of the SD memory card and removeit. Close the lid.SD memory cards must not be used or stored in anenvironment where they may bez Exposed to high temperatures/humidities;z Exposed to water droplets; orz Electrically charged.For storage, the SD memory card must be kept inserted into theAJ-SPX900E with the lid closed.4-10-2 Formatting, Writing and Reading anSD memory cardTo format an SD memory card, write settings data or read dataon an SD memory card, navigate the menu to the READ/ WRITE> screen from the FILE page.For an SD memory card formatted with a device that does notsupport SD standards, the message “FORMAT ERROR”appears at the upper right of the screen. In this case, reformatthe card as follows. Note that the indication “FORMAT ERROR”does not disappear if the SD memory card is replaced with thismenu page open. When the SD memory card is replaced,perform TITLE READ.It is not possible to read from or write to an SD memory cardduring INTERVAL REC mode operation by operating this menu.Perform the operation after stopping interval recording.To format an SD memory cardSD memory cards may be formatted via the thumbnail screen.For more information, see [6-15 Formatting SD memory cards].1 Navigate the menu to the CARD READ/WRITE>screen.2 Turn the JOG dial button to move the cursor to the menuoption CARD CONFIG.3 Press the JOG dial button to display the following message: 6'&$5'5($':5,7(!56(/(&7 5($':6(/(&7 :5,7(&$5'&21),*7,7/(5($'7,7/( &21),*"<(6 12ᤨࠫ
