Panasonic AK-UCU600P Operating Instructions Manual

Contents

Panasonic AK-UCU600P Operating Instructions Manual Manual pdf 132 page image

Specifications- 132 -SpecificationsPower supply AK-UCU600P/AK-UCU600PS : 100 V - 120 V AC ( ), 50 Hz/60 HzAK-UCU600E/AK-UCU600ES : 100 V - 240 V AC ( ), 50 Hz/60 HzPower consumption 500 W(Without camera connected: 90 W)Capacity for supplying power to a camera 240 V AC ( ), 1.46 A , 50 Hz/60 Hzindicates safety information.Operating temperature 0 °C to 40 °C (32 °F to 104 °F)Humidity 10% to 90% (no condensation)Dimensions(Width×Height×Depth) 424 mm × 88 mm × 401 mm (16-5/8 inches × 3-7/16 inches × 15-13/16 inches) (excluding protrusions)Weight Approx. 8.9 kg (19.6 lb)Video output3G/HD-SDI5 lines (embedded audio is supported only for HD signals)12G/6G/3G/HD-SDI2 linesHD-SDI1 line (shared with picture monitor output*2 )Analog composite2 lines (1 line shared with picture monitor output*2 )HD TRUNK/TICOoutputWhen HD TRUNK: HD-SDI, when TICO: 3G/HD-SDI1 lineReturn input3G-HD/HD/SD-SDI4 lines (RET1 input has active-through output)Analog composite1 linePrompter inputHD-SDI1 line (with active-through output)Analog composite2 lines (through output of 1 and input of 2 share the connector*2 )It is not terminated when the unit is turned OFF. No through output.Reference inputBB (black burst) / tri-level*11 line (automatic termination, connect to upper connector; BB signal and tri-level signal automatically recognized,with loop-through output)Microphone output 0 dBm/600 Ω2 lines (XLR, 3-pin, male)CommunicationIntercom input/output(ENG / PROD, 0 dBm, 600 Ω (4 W) / 1 V [p-p], 200 Ω (RTS), 4 W / RTS / CLRCOM)2 lines*2PGM input (0 dBm/600 Ω)2 linesTally input (red, green, yellow)1 input eachAUXWFM control6-bit (open collector output, terminal shared with camera microphone gain setting*2 )Camera microphone gain setting input5-bit (photo-coupler input, terminal shared with WFM control*2 )Down-conversion system setting input2-bit (photo-coupler input)TRUNK RS-422 / RS-232C2 lines*2FRONT ROPRS-4221 line, 16 V DC output (only one of this and REAR ROP can be selected at one time via the menu or the [ROPFRONT/REAR] selection switch on the front panel)