Panasonic AW-PH650N Operating Instructions Manual

Panasonic AW-PH650N Operating Instructions Manual Manual pdf 29 page image

29ConnectionsPrecautions when controlling theAK-HC1500 from the AW-CB400The AK-HC1500 supports the AK-HRP150 protocol andAW-CB400 protocol, and it is the AK-HRP150 protocolwhich was set before the AK-HC1500 was shipped from thefactory.When controlling the AK-HC1500 using the AW-CB400,follow the steps below to change the protocol setting ofAK-HC1500 from AK-HRP150 to AW-CB400. When changing the protocol before installationRefer to the operating instructions of the AK-HC1500,and change the protocol. When changing the protocol after installation Proceed with the installation following the steps givenin the section entitled “Installation”. Loosen the two top cover open/close bolts of thecamera housing, and open the top cover. Set the power switch of the AC adapter to ON. When the power of the AK-HC1500 has beenturned on, refer to the operating instructions of theAK-HC1500, and change the protocol. (Change thePROTOCOL setting on the SETTING menu to “4.”) Set the power switch of the AC adapter to OFF.Connections with AC adapter Disconnect the AC power cable which was alreadyattached. The cable used is purchased locally. Purchase a water-proof cable designed to be used outdoors. Use a cable which has a high enough capacity (AC 120 V2 A or more). Pass the cable through the rubber bushing for the ACpower input cable, and tighten it securely so that rainwater or drops of water will not seep inside.[Thickness of compatible cable: 1/4” to 5/16” (6.5 to 8.5 mm)diameter] Attach the power line (N, L) to the terminal block. Attach the ground line (FG) to the grounding screw ( ).AC INDC15 VOUTAC powerinput cableRubber bushingFGNL