Panasonic AW-PH650N Operating Instructions Manual

Panasonic AW-PH650N Operating Instructions Manual Manual pdf 9 page image

9Parts and their functionsMain unit (Pan/tilt head)        Main unit coverThe sunshade cover and main unit cover must beremoved when the cable compensation circuit or landingcharacteristics are to be changed. GripUsed in carrying, installing, or lifting the pan/tilt head. Sunshade coverThis cover protects the pan/tilt head from direct exposureto sunlight. Rotary armMount the housing after having installed the housingmount frame. I/F connectorConnect this to the I/F connector of the camera housing. Anti-fall wire boltThis bolt fastens the anti-fall wire which prevents the pan/tilt head from falling from its installed position. Pan/tilt head mounting holes (4)These holes are used to install and secure the pan/tilthead. Multi connector [MULTI]The supplied multi cable is connected here. Coaxial connector [SDI OUT]This is used for outputting the SDI or other signals whichhave been input from . Option connector [OPTION]The control signals of the controller’s OPTION button areoutput from this connector.Be absolutely sure to use a water-proof cable.The compatible connector is the R28-P8M4.8 made byTajimi Electronics Co., Ltd.A filter (supplied) must beinstalled around the cable.Install it at a distance within30 mm from the connector.Waterproof the filter usingtape or tube, for instance. Power connector [POWER]The supplied power cable is connected here. Grounding boltThis bolt is used to connect the wire for system grounding(frame grounding bolt). Coaxial connector [SDI IN]When an SDI card is installed in the camera, thisconnector is connected to the SDI signal outputconnector.OPTIONCableFilterWithin 30 mmfrom connector   Service connector( View of connector as seenfrom the cable)GND