Panasonic AW-PH650N Operating Instructions Manual

Panasonic AW-PH650N Operating Instructions Manual Manual pdf 32 page image

32LimitersBe absolutely sure to set the limiters (travel range) of the pan/tilt head before use.Depending on where the pan/tilt head system has been installed, obstacles may bepresent within the travel range with which the camera may come into contact.Contact with any such obstacle by the camera may cause malfunctioning oraccidents.In this case, contact can be prevented by setting the limiters directly before any suchobstacle.Multi function controller (AW-RP655) is used to set the limiters.The positions of four limiters — namely, the upper, lower, left-most and right-mostlimits of the travel range — can be set.Once they have been set, the positions will not be lost even after the power has beenturned off. Setting the limiters• Setting the upper limit of operating range1. Operate the controller, and turn the camera to theposition which will serve as the upper limit.2. While holding down the OK button on the controller,press TRACING/PRESET MEMORY button 47 .3. The setting is completed when TRACING/PRESETMEMORY button 41 [LIMIT ON] lights.4. Operate the controller, and check that the upper limit hasbeen set properly.• Setting the lower limit of operating range1. Operate the controller, and turn the camera to theposition which will serve as the lower limit.2. While holding down the OK button on the controller,press TRACING/PRESET MEMORY button 46 .3. The setting is completed when TRACING/PRESETMEMORY button 41 [LIMIT ON] lights.4. Operate the controller, and check that the lower limit hasbeen set properly.• Setting the left-most limit of operating range1. Operate the controller, and turn the camera to theposition which will serve as the left-most limit.2. While holding down the OK button on the controller,press TRACING/PRESET MEMORY button 44 .3. The setting is completed when TRACING/PRESETMEMORY button 41 [LIMIT ON] lights.4. Operate the controller, and check that the left-most limithas been set properly.• Setting the right-most limit of operating range1. Operate the controller, and turn the camera to theposition which will serve as the right-most limit.2. While holding down the OK button on the controller,press TRACING/PRESET MEMORY button 45 .3. The setting is completed when TRACING/PRESETMEMORY button 41 [LIMIT ON] lights.4. Operate the controller, and check that the right-most limithas been set properly.